1.Voltage for 220V, Power Voltage will be in between 220V+10% and 220V-10%, low voltage will cause relay couldn’t liable connection, high voltage will cause the demage of ultrasonic generator.
2.ultrasonic cleaning tank’s temperature for 40degree, prohibiting no-water operation in cleaning tank, or else it will demage
mchine, attention!
3. the fun of ultrasonic generator is to provide heat elimination , so we should keep nomal operation and good intake of heat elimination
4. to put ultrasonic cleaner in dry place, non-corrosion’s environment, the temp is not exceeds 30 degree.
5. to draw out power when we dismantal machine.
6.It will automatically rising temperature after 10-15mins, if operator clean it in 70degree more, no suggestion,it is not higher than 45degree。
7.To Prohibit dismantle with electricity, to make sure all is safe for operator.
8.it could get Rubber’s odor when start to heat, it is nomal,it will disapper after several weeks.
1,电压为220伏,功率电压将在220 v±10%,低电压将导致继电器无法吸合,高电压将导致超声波清洗机损坏。
2,切忌!超声波清洗槽无水状态下严禁开机,以免损坏机器。
3,超声波清洗器工作会产生一定的热量,要保持机器散热良好。
4,把超声波放在清洁干燥的地方,非腐蚀的环境中,温度不超过30度。
5,放/换清洗液时必须关断电源。
6,清洗机连续工作10—15分钟后会自动升温,如用加温方法清洗,则温度不宜超过70℃,环境温度不得高于45℃。
7,严禁带电拆、装清洗机,以防触电!!